Trimble Outdoors AgGPS 252 ユーザーズマニュアル

ページ / 72
OF
 
THE
 
POSSIBILITY
 
OF
 
ANY
 
SUCH
 
LOSS
 
AND
 
REGARDLESS
 
OF
 
THE
 
COURSE
 
OF
 
DEALING
 
WHICH
 
DEVELOPS
 
OR
 
HAS
 
DEVELOPED
 
BETWEEN
 
YOU
 
AND
 
TRIMBLE
. B
ECAUSE
 
SOME
 
STATES
 
AND
 
JURISDICTIONS
 
DO
 
NOT
 
ALLOW
 
THE
 
EXCLUSION
 
OR
 
LIMITATION
 
OF
 
LIABILITY
 
FOR
 
CONSEQUENTIAL
 
OR
 
INCIDENTAL
 
DAMAGES
THE
 
ABOVE
 
LIMITATION
 
MAY
 
NOT
 
APPLY
 
TO
 
YOU
.
NOTE
THE
 
ABOVE
 
LIMITED
 
WARRANTY
 
PROVISIONS
 
MAY
 
NOT
 
APPLY
 
TO
 
PRODUCTS
 
OR
 
SOFTWARE
 
PURCHASED
 
IN
 
THE
 
EUROPEAN
 
UNION
.
 
PLEASE
 
CONTACT
 
YOUR
 
TRIMBLE
 
DEALER
 
FOR
 
APPLICABLE
 
WARRANTY
 
INFORMATION
.
Notices
USA
NOTE – FCC Part 15 rules; paragraph 15.105
This equipment has been tested and found to comply with 
the limits for a Class A digital device, pursuant to Part 15 of 
the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference when the 
equipment is operated in a commercial environment. This 
equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the 
instruction manual, may cause harmful interference to radio 
communications. Operation of this equipment in a 
residential area is likely to cause harmful interference, in 
which case, you, the user, will be required to correct the 
interference at your own expense.
If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and the 
receiver.
– Connect the equipment into an outlet on a circuit 
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician 
for help.
Changes and modifications not expressly approved by the 
manufacturer or registrant of this equipment can void your 
authority to operate this equipment under Federal 
Communications Commission rules.
Europe
This product has been tested and found to comply with the 
requirements for the European Directive 75/322/EEC as 
amended by 2000/2/EC thereby satisfying the requirements 
for e-mark compliance for use in agricultural vehicles in the 
European Economic Area (EEA).
This product has been tested and found to comply with the 
requirements for a Class A device pursuant to European 
Council Directive 89/336/EEC on EMC, thereby satisfying the 
requirements for CE Marking and sale within the European 
Economic Area (EEA).
C
Warning – 
This is a Class A product. In a 
domestic environment this product may cause 
radio interference in which case you may be 
required to take adequate measures. 
Notice to Our European Union Customers
For product recycling instructions and more information, 
please go to www.trimble.com/environment/summary.html. 
Recycling in Europe
To recycle Trimble WEEE (Waste 
Electrical and Electronic Equipment, 
products that run on electrical power.), 
Call +31 497 53 24 30, and ask for the 
"WEEE Associate". 
Or, mail a request for recycling 
instructions to:
Trimble Europe BV
c/o Menlo Worldwide Logistics
Meerheide 45
5521 DZ Eersel, NL
Declaration of Conformity
This product conforms to the following standards, and therefore complies with the requirements of the R&TTE 
Directive 1999/5/EC, which specifies compliance with the essential requirements of EMC Directive 89/336/EEC and 
Low Voltage Directive 73/23/EEC.
The technical file is maintained at Trimble Navigation Limited, 749 North Mary Avenue, PO Box 3642, Sunnyvale, CA 
94088-3642, USA.
EMC Emissions
BSEN 55022:1998 (W/A1:00) Class A
EMC Immunity
EN 55024:1998
Safety
EN 60950:2000
Mark First Applied
03
Ag252_100B_UserGuide_ENG.book  Page iii  Thursday, July 28, 2005  4:06 PM