Patton electronic SMARTNODE 4900 ユーザーズマニュアル

1. Configure IP address

SmartNode 4900 User Manual 

To access the SmartNode, start the Telnet application. Type the default IP address for the router into the 
address field: 192.168.1.1. Accessing your SmartNode via a Telnet session displays the login screen. Type the 
factory default login: administrator and leave the password empty. Press the <Enter> key after the 
password prompt.

  

login:administrator

  

password: <Enter>

  

192.168.1.1>

After you have successfully logged in you are in the operator execution mode, indicated by > as command line 
prompt. With the commands enable and configure you enter the configuration mode.

  

192.168.1.1>enable

  

192.168.1.1#configure

  

192.168.1.1(cfg)#

Select the context IP mode to configure an IP interface.

  

192.168.1.1(cfg)#context ip router

  

192.168.1.1(ctx-ip)[router]#

Now you can set your IP address and network mask for the interface ETH 0/0 (WAN). Within this example a 
network 172.16.1.0/24 address is assumed. The IP address in this example is set to 172.16.1.99 (you should 
set this the IP address given to you by your network provider).

  

172.16.1.99(ctx-ip)[router]#interface eth0

  

172.16.1.99(if-ip)[eth0]#ipaddress 172.16.1.99 255.255.255.0

  

2002-10-29T00:09:40 : LOGINFO : Link down on interface eth0.

  

2002-10-29T00:09:40 : LOGINFO : Link up on interface eth0.

  

172.16.1.99(if-ip)[eth0]#

If your WAN connection's IP address is assigned via DHCP, refer to 
Chapter 21, "DHCP configuration" in the SmartNode Series Smart-
Ware Software Configuration Guide for information on configuring 
DHCP.  Copy this modified configuration to your new start-up con-
figuration. Upon the next start-up the system will initialize itself 
using the modified configuration.

  

172.16.1.99(if-ip)[eth0]#copy running-config startup-config

  

172.16.1.99(if-ip)[eth0]#

The SmartNode can now be connected to your network.