Patton electronic IP Phone SmartNode 4110 Series ユーザーズマニュアル

PPP Dial-up over ISDN

SmartWare Software Configuration Guide 

The local and remote E.164 number configuration on inbound destinations have different meanings than for 
outbound destinations. On inbound destinations these numbers are used to dispatch incoming calls to one of 
the configured inbound destinations.

Follow the steps below to create an inbound destination instance. Each destination contains all information 
needed to accept an incoming call and identify towards the remote party. You can create more than one 
inbound destination in order to filter inbound calls and to apply different PPP subscribers and PPP profile to 
call from different parties.

Mode: context cs/interface dialer

Creates an inbound destination to accept 
incoming calls from a certain remote party.

The incoming call must have the configured 
called-party number to be accepted. Use the 
no-form of the command to accept calls to all 
numbers.

The incoming call must have the configured 
calling-party number to be accepted. Use the 
no-form of the command to accept calls from 
all numbers.

Defines the data protocol that shall run over 
the established signalling connection. Cur-
rently only PPP is available, which is the 
default.

Indirectly binds to a spoofing IP interface over 
a PPP subscriber. The PPP subscriber contains 
all PPP protocol parameters (e.g. authentica-
tion protocol, credentials, multi-link, etc.)
See 

for further information.

Defines the PPP profile that shall be used. The 
PPP profile stores advanced PPP protocol 
parameters.
See 

further information.

Repeat steps 1-6 for all required backup pro-
viders you want to use.