TP-LINK TL-WPA281 ユーザーズマニュアル

 

26

 

value determines the time 

TS frames to a particular receiving station and 

lt in poor network performance 

, which indicates the 

nded that this function be enabled.   

h WLAN. This function will be disabled if WDS/Bridge is enabled.   

If you are not familiar with the setting items on this page, it's strongly recommended that you keep the 

fault values; otherwise, it may result in low wireless network performance.   

n information in 

 in Figure 3-19. This page shows MAC Address, Current Status, Received 

¾

 

Beacon Interval - Specifies a value between 40-1000 milliseconds. The beacons are the packets 
sent by the device to synchronize a wireless network. Beacon Interval 
interval of the beacons. The default value is 100.   

¾

 

RTS Threshold - Specifies the RTS (Request to Send) Threshold. If the packet is larger than the 
specified RTS Threshold size, the device will send R
negotiate the sending of a data frame. The default value is 2346.   

¾

 

Fragmentation Threshold - This value is the maximum size determining whether packets will be 
fragmented. Setting the Fragmentation Threshold too low may resu
since excessive packets. 2346 is the default setting and is recommended.   

¾

 

DTIM Interval - Determines the interval of the Delivery Traffic Indication Message (DTIM). You can 
specify the value between 1-255 Beacon Intervals. The default value is 1
DTIM Interval is the same as Beacon Interval.   

¾

 

Enable WMM - WMM function can guarantee the packets with high- priority messages being 
transmitted preferentially. It is strongly recomme

¾

 

Enable Short GI - This function is recommended for it will increase the data capacity by reducing 
the guard interval time.   

¾

 

Enable AP Isolation - Isolates all connected wireless stations so that wireless stations cannot 
access each other throug

)

provided de

Selecting Wireless > Wireless Statistics will allow you to see the wireless transmissio
the following screen shown
Packets and Sent Packets for each connected wireless station.   

 

Figure 3-19 Statistics of the device attached wireless stations 

¾

 

MAC Address - Shows the connected wireless station's MAC address. 

¾

 

A-ASSOC 

WN / Disconnected. 

¾

 

Sent Packets - Packets sent by the station. 

The connected wireless station's running status, one of STA-AUTH / ST

/ STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DO

¾

 

Received Packets - Packets received by the station.