Panasonic Arbitrator 360 ユーザーガイド

OPERATION

- Switch the power ON

(located on the bottom of TX unit)

- Prior to use, charge the unit by placing TX set in the

RX set at least for 3 hours

- Place TX on RX to sync the code

1. STANDBY mode

- While TX is placed in RX (No LED on)

2. TALK mode

- While TX is displaced from Rx, TX TALK button will be on

automatically in 2 seconds (Steady blue LED on). RX “TALK ON”
LED will not be on since it’s not recording

- While press TALK button on TX to trigger recording, TALK button

turns blue flickering rapidly. RX “TALK ON” LED will light up and
steady green

* When TX is out of range, RED LED is flickering for the notification

3. MODE: MODE Selection button.

Four mode is available as the notification function for
the unit status (Talk On/Off, Out of Range, Low Battery )
When user push this button, the mode is changing in order.
“ Beep Tone > Vibration > Beep and Vibration > None “

* When the battery is low, RED LED is flickering for the notification

4. “M” : Mute Button

When this button is pushed, audio data is not output during “Talk
On” mode. MUTE button will be red flickering slowly.

OPERATION

* LED Action for Out of Range

1. B

lue LED is steady on + red LED will be flickering for 30 ~ 40 sec,

then blue LED shut off and red LED will be flickering constantly

While TX comes back in range, blue LED will be back on (steady),

and red LED will be off

- Install the bracket by using the screws
- Slide RX Set onto the Bracket
- Connect the main cable to RX Set
- Connect the antenna (Internal Antenna or External Antenna

to the RX Set.

* Place external antenna on the windshield at the point (Horizontal

or Vertical) as following picture.

- Put the battery pack into TX Set

< External Antenna Installation >