Technicolor TU-HDT104A ユーザーズマニュアル

TU-HDT104A

 

 

7

The following illustrations show some examples for connecting this HD Digital 
Receiver. Select the connection that is best suited for your needs. Many other 
connections may be possible when optional devices such as RF cable splitters are 
included in your system. These devices may cause signal degradation and, if too 
many are used, poor quality picture and sound may result. 

Connect the TV antenna cable to the HD 
Digital Receiver RF IN connector.  Also 
connect the cable between your TV 
Antenna IN and RF

 

Out connector on the 

rear of the Digital Receiver.  This 
connection allows your TV set to receive 
normal analogue programs. (Refer to A) 

Adjust switch on the rear panel according to the format supported by your display 
device, and it contains three modes:  A, B and C 

Connect the YPbPr component video 
output socket on your digital receiver 
to your display device’s YPbPr 
component video input.  Be sure to 
match the colours on the RCA sockets 
with the coloured plugs.  (Refer to B) 

Note: When unit is in Mode A, there is 
no video output from the CVBS TV 
socket. 

Connect the D-sub socket to your 
display device.  (Refer to C) 

Note: Cable is not supplied.