Tascam RC-601mkII ユーザーズマニュアル

You can automatically stop at certain points in playback 
between two points or in rehearsal playback by setting 
memo points (A and B) in advance. 

z

  In the program playback mode, functions using the 

memo points described below cannot be used. (Memo 
points cannot be set or located.) Also, the remote control 
unit cannot be set to the program playback mode while in 
the memo mode.

1  In the monitor PAUSE mode, use the JOG/DATA dial to 

search for the desired position to set.

2 Press the SET key to set the remote control unit to the 

set mode. (The indicator lights.)

3 Press 

the 

A (or B) key. This sets the A (or B) point. 

When a point is set, the indicator on the key lights, and 
the SET indicator goes out.

•  If you set the remote control unit to the set mode in 

advance by using the SET key (the SET indicator lights), 
you can set points by pressing the A (or B) key at the 
desired point in the monitor playback mode (or monitor 
PAUSE mode). 

•  When a point is already set, it will be overwritten by the 

new point. 

z

  If the CD-601MKII is turned OFF or the disc is removed, 

all preset memo points will be cleared.

If you save memo points to memory on the CD-601MKII as 
disc information, you can call them when you load the same 
disc later on. (→ page 23 “Saving Disc Information”)

1 Press 

the 

RCL key. 

The RCL indicator lights. 

2 Press the A or B key (that is preset with a memo point). 

The preset point is located, and the remote control unit 
enters the online READY mode. (The RCL indicator goes 
out.)

There are two ways of confirming memo point times. 

1  While disc operations are stopped or in the monitor 

PAUSE mode, press the MEMO key to set the remote 
control unit to the memo mode. (The MEMO indicator 
lights.)

2  Press the key (A or B) of the memo point to confirm. 

The indicator corresponding to the key you pressed 
blinks, and the time of the memo point is displayed in the 
display window. 

3  After checking the time, press the key of the memo point 

again.

The indicator corresponding to the key you pressed 
stops blinking and lights, and the regular time display is 
returned to.

4 Press the MEMO key to exit the memory mode. (The 

MEMO indicator goes out.)

In the memo mode (while the MEMO indicator is lit), each 
press of the CHECK key displays the current time of points 
A and B. 

There are two ways of clearing currently set memo points. 

1  While disc operations are stopped, press the SET key 

to set the remote control unit to the set mode. (The 
indicator is lit.)

2  Press the key (A or B) of the memo point whose settings 

are to be cleared.

This clears the memo point settings, and the indicator of 
the memo point goes out.

The SET indicator goes out.

1  In the memo mode (while the MEMO indicator is lit), 

press the CHECK key until the memo point whose 
setting is to be cleared is displayed in the display 
window. 

2   Press the CLR key. 

This clears the memo point settings, and the indicator of 
the memo point goes out.

RC-601MKII_Eng.indd   19

3/24/2005   2:38:20 PM