Oricom TP110 ユーザーズマニュアル
4
3 Installation
3.1 Installing batteries (supplied) in the phone
You must install 4 AA Alkaline batteries (supplied) in the phone
base, or the display and Caller ID will not work.
base, or the display and Caller ID will not work.
Warnings
Before opening the battery compartment, make sure the telephone is
disconnected from the telephone line and the mains power supply.
disconnected from the telephone line and the mains power supply.
1. Use a flat-blade screwdriver or tip of a pen to lift and remove the battery
compartment door.
2. Insert four AA batteries into the compartment as indicated by the polarity
symbols.
3. Snap the battery compartment door back into place.
When this
symbol appears on the display or the display dims, replace
the batteries. Always use 4 new high quality Alkaline AA batteries.
3.2 Connecting the telephone
1. Plug one end of the telephone cable supplied into the TEL. LINE jack at
the back of the telephone base.
2. Plug the other end of the telephone cable into the wall outlet.
3. Plug one end of the curly cord into the socket on the handset.
4. Plug the other end of the curly cord into the left side of the telephone.
3. Plug one end of the curly cord into the socket on the handset.
4. Plug the other end of the curly cord into the left side of the telephone.