ONKYO HT-R590 ユーザーズマニュアル

En

With the supplied calibrated microphone, 
Audyssey 2EQ

®

 automatically determines the number of 

speakers connected, their size for purposes of bass 
management, optimum crossover frequencies to the 
subwoofer (if present), and distances from the primary 
listening position.
Audyssey 2EQ then removes the distortion caused by 
room acoustics by capturing room acoustical problems 
over the listening area in both the frequency and time 
domain. The result is clear, well-balanced sound for 
everyone. Audyssey 2EQ can be used with 
Audyssey Dynamic EQ

®

 and 

Audyssey Dynamic Volume

®

 (

Before using this function, connect and position all of 
your speakers.
Audyssey 2EQ offers two ways of measuring: the 
“Audyssey Quick Start” and “Audyssey 2EQ Full 
Calibration”.
• “Audyssey Quick Start” uses the measurement from 

one position to perform the speaker setting only.

• “Audyssey 2EQ Full Calibration” uses the 

measurement from three positions to correct room 
response in addition to the speaker setting.

The Quick Start takes 2 minutes and Full Calibration takes 
about 10 minutes.
Total measurement time varies depending on the number 
of speakers.

To create a listening environment in your home theater 
that all listeners will enjoy, Audyssey 2EQ takes 
measurements at up to 3 positions within the listening 
area. Position the microphone at ear height of a seated 
listener with the microphone tip pointed directly at the 
ceiling using a tripod. Do not hold the microphone in your 
hand during measurements as this will produce inaccurate 
results. 

a First measurement position

Also referred to as the Main Listening Position, this 
refers to the most central position where one would 
normally sit within the listening environment. 
Audyssey 2EQ uses the measurements from this 
position to calculate speaker distance, level, polarity, 
and the optimum crossover value for the subwoofer.

b Second measurement position

The right side of the listening area.

c Third measurement position

The left side of the listening area.

The distances from position 

a to b and a to c must be 

at least 1 meter (3.3 ft.). 

• Make the room as quiet as possible. Background noise and Radio 

Frequency Interference (RFI) can disrupt the room 
measurements. Close windows, televisions, radios, air 
conditioners, fluorescent lights, home appliances, light dimmers, 
or other devices. Silence the cell phone (even if it is not in use) 
or place it away from all audio electronics.

• The microphone picks up test tones played through each speaker 

as Audyssey 2EQ Room Correction and Speaker Setup runs.

• Audyssey 2EQ Room Correction and Speaker Setup cannot be 

performed while a pair of headphones is connected.

TV

a

c

b

: Listening area

a to c: Listening position