ONKYO DR-815 ユーザーズマニュアル

 

58

 

The ACCUCLOCK function normally uses the FM station with the strongest signal to set the clock. If the clock cannot 
be set properly using that station, you can specify which FM station the ACCUCLOCK function should use. This must 
be an FM station that supports RDS CT (Clock Time) information.

 

You can also perform the operation by using the TIMER, ENTER, 

/

, and MODE buttons on the remote control-

ler.

 

“Clock” appears on the display.
If the clock has already been set, a timer option appears instead. In this case, you’ll need to 
press TIMER repeatedly until “Clock” appears.

 

“*AccuClock*” or “AccuClock” appears on the display. If “Manual Adjust” appears, turn 
MULTI JOG to select “*AccuClock*” or “AccuClock”.

 

The display appears as shown.

 

Pressing YES/MODE toggles the tuning mode between “Auto Tuning” and “Manual Tuning.”
The RDS indicator appears when tuned into a station that supports RDS, as shown.

 

While the clock is being set, “Wait” flashes on the display. It may take a few minutes to set the 
clock. When the clock has been set, the message “Clock Adjusted” scrolls across the display, 
then the day and time are displayed for a while.

 

• If the clock has not been set correctly, the message “No clock signal on RDS” scrolls across 

the display. Specify another FM station and try again, or set the clock manually (page 59).

• If you don’t want the clock to be updated automatically, you can turn off the ACCUCLOCK 

function (page 25).