Omron SYSMAC C200HW-ZW3AT2-E-V2 ユーザーズマニュアル
5-3
Section
L: Data Link
74
The message for the comparison results will be displayed in the lower part of
the screen as follows:
When comparison errors continue on the next page:
the screen as follows:
When comparison errors continue on the next page:
“Continue”
When the comparison error screen is the last page:
“Last page”
When inconsistent data is found, the data in the memory will be displayed in
the upper row and the data at the node will be displayed in the lower row.
(Consistent data will not be displayed.)
the upper row and the data at the node will be displayed in the lower row.
(Consistent data will not be displayed.)
6. If the comparison error screen extends across more than one page, use the
F4 (Pre Pg) and F5 (Nxt Pg) Keys to switch the screen and display the re-
sults. The Page Up and Page Down Keys can also be used to switch the
screen.
To display the comparison errors for another node, press the Escape Key to
exit from the comparison error screen, then repeat the procedure from
step 5.
sults. The Page Up and Page Down Keys can also be used to switch the
screen.
To display the comparison errors for another node, press the Escape Key to
exit from the comparison error screen, then repeat the procedure from
step 5.
7. After checking the comparison results, press the F10 (End) Key.
5-3-11 Deleting Data Link Tables from Nodes — D: Delete Table
“D: Delete table” is used to delete the data link tables set at one or more nodes.
Note
1) Data link tables cannot be deleted from a node that is currently participating
in the data links.
2) The nodes for which the number of nodes set in the data link table in the
computer memory is 0 will be automatically selected as the nodes from
which data link tables are to be deleted. Therefore, data link tables can be
deleted from only the nodes that are not to participate in the data links. You
can also change the target nodes for deletion.
which data link tables are to be deleted. Therefore, data link tables can be
deleted from only the nodes that are not to participate in the data links. You
can also change the target nodes for deletion.
3) Always delete the data link tables from the nodes that are not be participat-
ing in the data links.
1, 2, 3...
1. Select “D: Delete table” from the Data Link Menu. The following window will
be displayed to prompt you to specify the nodes from which data link tables
are to be deleted.
are to be deleted.
2. Specify the address of the Controller Link Network containing the nodes
from which data link tables are to be deleted. Enter the network address with
Numeric Keys, then press the Enter Key.
When the Enter Key is pressed, the nodes on the specified network will be
checked and displayed in ascending order of node address.
When node addresses are displayed, YES or No will be displayed as fol-
lows, depending on the number of nodes set in the data link table in the
memory:
Nodes for which the number of nodes is not 0: YES (data link tables deleted)
Nodes for which the number of nodes is 0: No display (data link tables not
deleted)
Numeric Keys, then press the Enter Key.
When the Enter Key is pressed, the nodes on the specified network will be
checked and displayed in ascending order of node address.
When node addresses are displayed, YES or No will be displayed as fol-
lows, depending on the number of nodes set in the data link table in the
memory:
Nodes for which the number of nodes is not 0: YES (data link tables deleted)
Nodes for which the number of nodes is 0: No display (data link tables not
deleted)