Novell ZENworks Endpoint Security Management 3.5 ユーザーズマニュアル
ZENworks® ESM 3.5
Administrator’s Manual
129
•
IP - This type limits the address to 15 characters, and only containing the num-
bers 0-9 and periods (example: 123.45.6.189). IP addresses may also be
entered as a range (example: 123.0.0.0 - 123.0.0.255)
bers 0-9 and periods (example: 123.45.6.189). IP addresses may also be
entered as a range (example: 123.0.0.0 - 123.0.0.255)
•
MAC - This type limits the address to 12 characters, and only containing the
numbers 0-9 and the letters A-F (upper and lower case); separated by colons
(example: 00:01:02:34:05:B6)
numbers 0-9 and the letters A-F (upper and lower case); separated by colons
(example: 00:01:02:34:05:B6)
Step 5: Select the ACL Behavior drop-down box and determine whether the ACLs listed should be
Trusted (allow it always even if all TCP/UDP ports are closed) or Non-Trusted (block
access)
access)
Step 6: If Trusted, select the Optional Trusted Ports (TCP/UDP) this ACL will use. These ports
will permit all ACL traffic, while other TCP/UDP ports will maintain their current
settings. Selecting ‹None› means any port may be used by this ACL
settings. Selecting ‹None› means any port may be used by this ACL
Step 7: Click Save. Repeat the above steps to create a new setting
To associate an existing ACL/Macro to this firewall setting:
Step 1: Select Access Control List from the component tree and click the Associate Component
button
Step 2: Select the ACL(s)/Macro(s) from the list
Step 3: The ACL behavior settings may be re-defined
Note:
Changing the settings in a shared component will affect ALL OTHER instances of this same component.
Use the Show Usage command to view all other policies associated with this component.
Use the Show Usage command to view all other policies associated with this component.
Step 4: Click Save