New Transducers TR-5001 ユーザーズマニュアル

 

CPU Installation 

 

The TR-979 Industrial SBC Card provides a 478-pins ZIF socket 

for Pentium 4 processors with FC-PAG2 package.  

 

To Install a CPU, first turn off your system and remove its cover. Locate 

the ZIP socket and open it by first pulling the lever sideways away from 

the socket then upwards to a 90-degree right angle. Insert the CPU with 

the correct orientation. Use the notched corner of the CPU with the white 

dot as your guide. The white dot should point towards the end of the 

lever. Notice that there is a blank area where one hole is missing from 

that corner of the square array of pin holds. Because the CPU has a 

corner pin for three of the four corners, the CPU will only fit in one 

orientation. With the added weight of the CPU fan, no force is required 

to insert the CPU. Once completely inserted, hold down on the fan and 

close the socket lever. 

 

To disassembly the processor, simply pull the lever sideways away from 

the socket then upward to a 90-degree right angle. You can take the CPU 

out from the socket without help of any tool. 

 

After installing the processor into the Socket, ensure that the CPU fan is 

installed first. Without a fan circulating air on the CPU, the CPU can 

overheat and cause damage to both CPU and SBC card. 

 

WARNING!: If no FAN circulating Air on the CPU, the processor 

might been overheated and damage both CPU and SBC components. 

 

IMPORTANT: You must set jumpers for “CPU FSB speed” depending 

on the CPU that you install.