Netgear WC7600 参照マニュアル
Introduction
14
ProSAFE Wireless Controller WC7600
Back Panel Features
The wireless controller comes with a single internal power supply but supports an optional
second power supply for power redundancy. The power supplies are hot-swappable.
second power supply for power redundancy. The power supplies are hot-swappable.
The following figure shows the back panel of the wireless controller with a single internal
power supply, the power supply connector, and two double fans.
power supply, the power supply connector, and two double fans.
Power supply connector
Figure 3. Back panel
Status LED
(continued)
Off
The wireless controller does not have power.
Blinking yellow
Firmware is being upgraded.
Fan LED
Green
The fans are functioning correctly.
Yellow
One or more fans are not functioning correctly.
Stack Master
LED
LED
Green
The wireless controller functions as the master controller in a stack.
Yellow
The wireless controller functions as a slave controller in a stack.
SFP slot LEDs Green
The slot is operating at 10G.
Blinking green
Data is being transmitted or received at 10G.
Yellow
The slot is operating at 1G.
Blinking yellow
Data is being transmitted or received at 1G.
Left Ethernet
port LED
port LED
Off
The port has no physical link, that is, no Ethernet cable is plugged into the
wireless controller (see
wireless controller (see
297).
Green
The port has detected a link with a connected Ethernet device.
Blinking green
The port transmits or receives data.
Right Ethernet
port LED
port LED
Off
The port has no physical link, that is, no Ethernet cable is plugged into the
wireless controller (see
wireless controller (see
297).
Green
The port is operating at 1000 Mbps.
Yellow
The port is operating at 100 Mbps or 10 Mbps.
Table 1. LED functions (continued)
LED
Status
Description