Netgear WC7600 参照マニュアル

A more complex configuration consists of a single wireless controller that controls a collection 

of access points that are organized in access point profile groups and might use several 
profiles in each access point profile group.



Configure the system and network settings of the wireless 
controller:

 

Configure the country code of operation.

Configure the time settings.

Configure the IP address of the wireless controller.

Verify that VLAN 1 is set as the management VLAN and is 
marked as untagged. 
 
By default, VLAN 1 an untagged management VLAN.

DHCP option 43 (vendor-specific information) must be 
enabled on an external DHCP server. 

If no network DHCP 

server is accessible to the access points, configure the 
wireless controller’s DHCP server. 

Specifying an internal 

DHCP server on the wireless controller automatically enables 
DHCP option 43 with the IP address of the wireless controller.

 

Configure up to eight access point profile groups, and for each 
access point profile in a group, do at least the following:

 

Configure an SSID for wireless access.

Configure the network authentication and data encryption.

 Assign the VLAN.

If necessary for the selected network authentication option, 
configure the authentication server.

Run the Discovery Wizard and add the access points to the 
managed access point list.

Assign the access points to the access point profile groups (also 

referred to as WLAN groups).