Netgear WC7600 参照マニュアル

To connect to the wireless controller for initial configuration, follow the steps in this section. 
You can also access the ProSAFE Wireless Controller WC7600 Installation Guide that you can 
download from 

.



Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 as 
the subnet mask.

Connect the wireless controller to the computer through the network or directly to the 
wireless controller’s Ethernet port.

Connect the power cord from the wireless controller to an AC power outlet.

Verify that the following LEDs on the front panel are lit:

Power

The green Power LED is lit. If the Power LED is not lit, check the connections and check to see 
if the power outlet is controlled by a wall switch that is turned off.

Status

The Status LED is lit yellow while the wireless controller is initializing. After approximately two 
minutes, when the wireless controller has completed its initialization, the Status LED turns 
green.

Fan

The green Fan LED is lit, indicating that the fans are functioning correctly.

Ethernet

The right Ethernet port LED is lit green for a 1000 Mbps connection or yellow for a 100

 

Mbps or 

10 Mbps connection. If it is not, make sure that the Ethernet cable is securely attached at both 
ends.

Before you log in to the wireless controller, make sure that you have followed the steps in the 
previous section, 

.

To log in to the wireless controller, you must use a web browser such as Microsoft Internet 
Explorer

 

9 or 10, or the latest Mozilla Firefox version, or Google Chrome 24 or later with 

JavaScript, cookies, and SSL enabled.



Open your browser and type http://192.168.0.250 in the browser’s address field.