Netgear WND930 参照マニュアル
Initial Setup
24
Outdoor High Power Wireless N Access Point
6.
Connect the Ethernet cable from the access point to a LAN port on your router, switch or
hub.
hub.
7.
Connect a power sourcing equipment (PSE) to one of the PoE ports on the access point,
using a cable gland to protect the Ethernet cable.
using a cable gland to protect the Ethernet cable.
If your router switch or hub supplies PoE, skip this step.
Note:
You must supply either IEEE 802.3at power to at least one LAN port or
IEEE 802.3af power to two LAN ports to power the access point. You
must supply IEEE 802.3at power to both LAN ports to receive PoE
power out.
IEEE 802.3af power to two LAN ports to power the access point. You
must supply IEEE 802.3at power to both LAN ports to receive PoE
power out.
8.
Using a wireless device, verify connectivity by using a browser to connect to the Internet.
Connect Optional External Antennas
The access point supports optional external antenna model ANT24501B. To use the optional
antennas, you must attach the antennas and then log in to the access point to enable
external antennas.
antennas, you must attach the antennas and then log in to the access point to enable
external antennas.
To install optional external 2.4 GHz or 5 GHz
antennas:
1.
Attach the 2.4 GHz or 5 GHz antennas to the
corresponding connectors on the side panels of
the access point.
corresponding connectors on the side panels of
the access point.
2.
Enable the antennas, as described in the following
procedure.
procedure.
To enable the external 2.4 GHz or 5 GHz antennas:
1.
Launch a web browser on the computer that is
connected to the access point.
connected to the access point.
2.
In the address field of the browser, enter
http://192.168.0.100.
http://192.168.0.100.
A login prompt displays.
3.
Enter the user name and password.
The user name is admin and the default
password is password.
password is password.
The General screen displays.