Neuton CE 6.2 ユーザーズマニュアル
NEUTON CE 6.2 Battery-Powered Mower -
Safety & Operating Instructions
19
⇒ Status Indicator Light
The green Status Indicator Light on the Lower
Crossbar (Figure 16) lights up when you install
a charged Battery and insert the Safety Key.
Crossbar (Figure 16) lights up when you install
a charged Battery and insert the Safety Key.
NOTE: A green Status Indicator Light does not
guarantee that the Battery is fully
charged, only that it has some charge, the
Safety Key has been inserted, the electrical
system is ready, and that the Mower can
be started.
charged, only that it has some charge, the
Safety Key has been inserted, the electrical
system is ready, and that the Mower can
be started.
IF THE GREEN STATUS INDICATOR LIGHT GOES OUT, DO NOT OPERATE THE MOWER AGAIN UNTIL THE
BATTERY IS FULLY CHARGED. IF YOU DO OPERATE THE MOWER WITH THE GREEN STATUS INDICATOR
LIGHT OUT, THIS WILL RESULT IN DECREASED CHARGING CAPACITY.
BATTERY IS FULLY CHARGED. IF YOU DO OPERATE THE MOWER WITH THE GREEN STATUS INDICATOR
LIGHT OUT, THIS WILL RESULT IN DECREASED CHARGING CAPACITY.
NOTE: Although you may notice that a short period of rest may restore the Status Indicator Light, you
still must fully charge the Battery before continuing to mow. For best results, be sure to always
fully charge the Battery for eight (8) to twenty-four (24) hours after every use.
fully charge the Battery for eight (8) to twenty-four (24) hours after every use.
⇒ Cutting Height Lever
The Cutting Height Lever (Figure 17), located
under the Access Cover, allows you to easily
adjust how high or low you cut the grass. Notice
that there are four (4) different Height Positions.
under the Access Cover, allows you to easily
adjust how high or low you cut the grass. Notice
that there are four (4) different Height Positions.
To easily move the Cutting Height Lever, hold
the Handlebar with your right hand to keep the
Mower steady and adjust the Lever with your left
hand.
the Handlebar with your right hand to keep the
Mower steady and adjust the Lever with your left
hand.
To easily adjust this Lever, push the Lever out of
its present notched position and move the Lever
up or down to the desired level. When you reach
the desired level, simply release the Lever into
the notch.
its present notched position and move the Lever
up or down to the desired level. When you reach
the desired level, simply release the Lever into
the notch.
⇒ Power/Mode Switch
The Power/Mode Switch (Figure 18) controls the
Mower, Power, and optional Trimmer. This
Switch has three (3) settings.
Mower, Power, and optional Trimmer. This
Switch has three (3) settings.
•
Mower (rear position), used for normal
mowing; and
mowing; and
•
Power OFF (center position), used to
conserve Battery power (green Status
Indicator Light goes out); and
conserve Battery power (green Status
Indicator Light goes out); and
•
Auxiliary (forward position), used when
operating the Optional Trimmer.
operating the Optional Trimmer.
Figure 16
Figure 17
Figure 18
Status Indicator Light
Cutting Height Lever
Power/Mode Switch
TIP
Access Cover
Positions
1=1.2" (3.0cm)
2=1.5" (3.8cm)
3=2.0" (5.1cm)
4=2.8" (7.0cm)
2=1.5" (3.8cm)
3=2.0" (5.1cm)
4=2.8" (7.0cm)