Neuton CE 6.2 ユーザーズマニュアル
NEUTON CE 6.2 Battery-Powered Mower -
Safety & Operating Instructions
23
Chapter 4:
Operating Your NEUTON Mower
This chapter explains how to Start, Stop, and adjust the Cutting Height of your Mower.
NOTE: If the Mower Battery is not fully charged or if you are unpacking a new Mower for the first time, read
“Chapter 5: Charging and Caring for the Battery” before operating the Mower. You should charge
the Battery for eight (8) to twenty-four (24) hours before use.
the Battery for eight (8) to twenty-four (24) hours before use.
Pre-Start Checks
DO NOT INSERT THE SAFETY KEY UNTIL YOU HAVE COMPLETED ALL OF THE PRE-START CHECKS AND YOU
HAVE MOVED THE MOWER TO THE AREA THAT YOU ARE GOING TO MOW.
HAVE MOVED THE MOWER TO THE AREA THAT YOU ARE GOING TO MOW.
Perform the following checks each time before operating your Mower.
•
Check under the Mower Deck and make sure that the Blade is attached securely. Inspect for any
visible damage to the Blade or Deck, and remove any accumulation of dirt, dust, or dried grass
clippings.
visible damage to the Blade or Deck, and remove any accumulation of dirt, dust, or dried grass
clippings.
•
Make sure all Knobs, Bolts, Attachments, Guards, and Covers are in place and securely attached.
•
Attach the Side Discharge Chute, the Rear Bagger, or the Mulching Plug.
•
Set the Mower to the desired Cutting Height. See “Adjusting the Cutting Height” on page 24 for
details.
details.
•
Be sure the Battery is fully charged.
•
Be sure to set the Power/Mode
Switch to “Mowing” (the “Mowing” side of the switch, toward you,
is pushed down).
•
Push the Mower (before starting it) to the lawn area that you wish to mow.
NOTE: The length of time that a Battery can hold a charge while mowing depends upon lawn conditions;
tall or thick grass makes the Mower work harder causing the Battery to discharge faster.