NEC N 1093100 ユーザーズマニュアル
12xx-Slots
121x-Lines
1213-T1/E1 Card Setup
618
◆ System Options: 1001-1702
DSX Software Manual
Default
•
•
Yes
(1) - Enabled
1213-05: Zero Suppression
(B8ZS/HDB3)
Use this option to enable or disable zero suppression for the PCB transmit path.
If enabled, T1 PCBs use B8ZS zero suppression, while E1 PCBs use HDB3 zero suppression.
If disabled, the PCB has no transmit zero suppression. (Note the receive zero suppression is always enabled.)
Zero suppression may help prevent T1 PCB clocking problems, but should always be set for compatibility
with the connected telco.
with the connected telco.
Options
•
•
No
(0) - Disabled
•
Yes
(1) - Enabled
Default
•
•
Yes
(1) - Enabled
1213-06: Loopback Mode
(Loopback Mode)
Use this option to enable T1 PCB loopback. Although loopbacks are generally used for factory testing, you may
find Remote and Payload Loopback helpful for on-site troubleshooting. The available loopback entries are:
find Remote and Payload Loopback helpful for on-site troubleshooting. The available loopback entries are:
None
❥
Loopback is not enabled.
Metallic
❥
This option loops the T1 PCB internal analog output to the PCB internal analog input. The PCB external
(telco side) connection is isolated during this test. Metallic Loopback is not normally used as a field test.
Digital
❥
This option loops the T1 PCB internal digital output through the PCB’s framer chip and then back to the
PCB internal digital input. Digital Loopback is not normally used as a field test.
Remote
❥
This option loops any analog signal on the T1 PCB external (telco side) receive tip and ring to the exter-
nal (telco side) transmit tip and ring. Remote Loopback may be useful for field testing because it loops
any analog test signal on the PCB receive tip and ring back to the transmit tip and ring.
any analog test signal on the PCB receive tip and ring back to the transmit tip and ring.
ST-Bus
❥
This option loops the T1 PCB internal digital output to the PCB internal digital input. It does not loop
back through the framer chip. ST-Bus Loopback is not normally used as a field test.
Payload
❥
This option loops any digital signal on the T1 PCB external (telco side) receive tip and ring to the exter-
nal (telco side) transmit tip and ring. Payload Loopback may be useful for field testing because it loops
any digital test signal on the PCB receive tip and ring back to the transmit tip and ring.
any digital test signal on the PCB receive tip and ring back to the transmit tip and ring.