NEC Storage Manager IS015-9E ユーザーズマニュアル

Chapter 4 Functions of ReplicationControl

164

[Execution Conditions]

To execute the wait command, the following conditions must be satisfied:

(i)

The target MV and RV are paired.

(ii) The target MV or RV has been registered in the volume list.

(iii) The volume list is not being created or updated.

(iv) The disk array where the specified MV and RV are stored is not in the Freeze state.

(v) Specifying a volume of a dynamic disk or a GPT-format partition disk is not allowed (Windows

only).

(vi) The iSM dedicated special file is not being created (HP-UX version UNIX only).

(vii) When an LVM volume group or a VxVM disk group is specified, the target volume group or disk

group must be active (UNIX only).

(viii) When specifying the combination of an LVM volume group or a VxVM disk group with a special

file name (logical disk name), you must specify the same number of logical volumes that make up

the volume group or disk group as MV (RV) on the special file name (logical disk name) side.

In this case, Copy is performed in specified sequential order (UNIX only).

The above execution conditions (ii), (iii), (v), (vi), (vii), and (viii) are not applicable when conducting a

joint operation with the iSM (replication management).

Figure 4-30 shows the Wait execution conditions.

Figure 4-30 Execution Conditions for Wait Command

Target Pair

(i)

Pair setting

(ii) MV or RV has been registered in the volume list.

(iii) The volume list is not being created or updated

(iv) Disk array is not in the Freeze state.

(v) The disk is not a dynamic disk or GPT-formatted

partition disk.

State

Transition