Namco Bandai Games 90500159 ユーザーズマニュアル
Page 59
8-6
Replacing the Gun Solenoid
1.
Remove the Gun Assembly.
(see section 8-3 page 56 Replacing the Gun
Solenoid Assy)
2.
Remove the Gun Slides.
(see section 8-4 page 57)
3.
Remove the gun covers.
(see section 8-5 page 58)
4
Disconnect the solenoid connector.
5.
Remove 1off cap bolt (M3x10) and remove the solenoid bracket.
6.
Remove 1off cup screw (M3x8) and detach the ground wire.
7.
Remove 2off cup screws (M4x6)
and remove the slide guide.
and remove the slide guide.
8.
Slacken the nut (16mm dia.) and
remove the solenoid complete with
plunger.
remove the solenoid complete with
plunger.
9.
Pull the plunger out from the
solenoid taking care not to lose
the spring.
solenoid taking care not to lose
the spring.
10.
Reassemble in reverse order.
Note: When reassembling, match the D-type hole of the solenoid bracket to the D
shape of the solenoid and ensure that the ‘E’ rings and spacers are in their correct
positions.
Note: When reassembling, match the D-type hole of the solenoid bracket to the D
shape of the solenoid and ensure that the ‘E’ rings and spacers are in their correct
positions.
Cap bolt (M3x10)
Solenoid
Solenoid bracket
Connectors
Ground terminal
Toothed lock washer
Cup screw (M) (M3x8)
Nut (nominal dia. 16mm)
Cup screws (M) (M4x6)
Slide guide
Plunger
Solenoid
Solenoid
Spacers
Slide guide
Plunger
E-shaped snap rings
Solenoid bracket
Outlet for harness
(Make sure that the harness faces down.)