KVH Industries TracVision M5 ユーザーズマニュアル

23

These supplemental instructions explain how to 
configure the system for DIRECTV HDTV using 
KVH’s optional HDTV converter. To complete a 
basic, single-receiver configuration, you will 
need the following components:

• HDTV converter (KVH part #02-1431)

• Splitter (KVH part #19-0366)

• DIRECTV  HD  receiver

• HDTV  television

The HDTV converter adjusts the signal frequency 
of DIRECTV’s 110 satellite, allowing the system 
to receive its high-definition channels. This 
configuration also allows the system to receive 
signals from DIRECTV’s 101 and 119 satellites for 
a three-satellite (Trisat) setup.

Wiring a Single DIRECTV HD Receiver

Follow these steps to connect the HD receiver.

1. Connect an RF coax cable from the “HDTV 

Control” jack on the MCP to the “Control 

Input” jack on the HDTV converter (see 

2. Connect the RF1 cable from the antenna to 

the “RF Input” jack on the HDTV converter.

3. Connect an RF coax cable from the “RF Out” 

jack on the HDTV converter to either of the 

“Out” jacks on the splitter.

4. Connect an RF coax cable from the “Tone 

Detect” jack on the MCP to the other “Out” 

jack on the splitter.

5. Connect an RF coax cable from the “Input” 

jack on the splitter to the “Satellite In” jack on 

the DIRECTV HD receiver.

If you wish to connect two or more HD 

receivers to the antenna, you will need to 

install an active multiswitch. See the next 

section for special wiring instructions.

HDTV
Converter
(02-1431)

MCP

Secondary (Non-HD) Receiver - Optional

Primary (HD) Receiver

RF1

RF2

This receiver controls
satellite selection

Antenna

Splitter
(19-0366)

RF

RF

Switchplate

Figure 41:  Wiring a Single DIRECTV HD Receiver

DIRECTV HDTV Installation

A

Appendix