KLH KC-120ST ユーザーズマニュアル

Antenna preparation 
 
Unpack the AM antenna and snap it’s cylindrical end onto the base/mounting 
plate.  Stretch out the twisted cord and Insert the small rectangular plug at the 
end into the socket located at (19) on the back of the radio.  Note, this plug is 
keyed and only fits one way.  Orient the AM antenna for best reception of your 
favorite AM station. 

 
Unroll the FM wire antenna (20) and stretch it out.  This antenna is permanently 
attached to the back of the radio.  Position this antenna for best reception of your 
favorite FM station.   
 
Select a location for your radio 
 
Because the radio generates heat during operation it is necessary to provide 
open space around it for proper cooling.  Failure to do so can significantly reduce 
the service life. 
 
Do not place the radio near a heater or in direct sunlight.  In addition, the radio 
should not be placed atop electronic devices that generate heat. 
 
In most situations the best radio reception will be had when the KC-120ST and 
its antennas are near a window.  This is particularly true for the “Atomic Clock” 
radio receiver. 
 
For proper remote control operation there must be an unobstructed path between 
the remote and the radio face. 
 
The KC-120ST includes an auxiliary input allowing sound from computers, TV 
sets, MP3 players, portable tape players, or other device with a headphone 
output to play through the KC-120ST.  If this feature will be used, keep in mind 
the length of the interconnect cable needed when selecting the location. 
 
Connecting power 
 
Connect the supplied power adapter to the jack (22) on the back of the radio.  
Plug the adapter into an un-switched AC outlet.  Turn on the radio and verify 
operation.  Use only the supplied adapter.  Damage resulting from the use of 
adapters supplying the wrong voltage or polarity is not covered by the warranty.