Juniper Networks fi-6000NS ユーザーズマニュアル

Network Scanner fi-6000NS Operator's Guide 

293

C

Scanning

Feed Error: Document(s) may not 
match the set paper size, ADF may 
have grabbed more than one sheet, or 
documents may not be suitable for 
scanning. Remove the documents 
from the ADF, check them and try 
again. If problem persists, consult the 
manual.

Press the ADF release button to 
open the top cover, and remove the 
documents from the ADF. If more 
than one sheet has been fed, reset 
the document and try again.
Check that the actual document(s) 
size matches the paper size 
specified in the "Paper Size" 
screen. If not, specify the paper 
size again.
For details, refer to "4.7.3 Paper 
Size" (page 175).

Insufficient memory. Try turning the 
power off and back on again. If 
problem persists, the administrator 
should contact the FUJITSU scanner 
dealer or an authorized FUJITSU 
scanner service provider for help.

Try the following:
• Reduce the size of the scan data 

or set a lower resolution level, 
and try again.

• System might be unstable. Try 

turning the power off for ten 
seconds, and back on again. If 
the error status persists, contact 
your FUJITSU scanner dealer 
or an authorized FUJITSU 
scanner service provider.

An error has occurred. Some pages 
were skipped. Try again after turning 
the power off and back on again. If 
problem persists, the administrator 
should contact the FUJITSU scanner 
dealer or an authorized FUJITSU 
scanner service provider for help.
Number of Skipped Pages: 

Try turning the power off for ten 
seconds, and back on again. If the 
problem persists, contact your 
FUJITSU scanner dealer or an 
authorized FUJITSU scanner 
service provider.

Scanner hardware failure. The 
administrator should contact the 
FUJITSU scanner dealer or an 
authorized FUJITSU scanner service 
provider for help.

Try turning the power off for ten 
seconds, and back on again. If the 
problem persists, contact your 
FUJITSU scanner dealer or an 
authorized FUJITSU scanner 
service provider.