JVC Recording Equipment KA-F5602U ユーザーズマニュアル
10
Part Names and Functions
Getting Started
INTERCOM
INCOM MIC
INCOM LEVEL
ON
OFF
MAX
MIN
DYNAMIC
CARBON
PUSH
CALL
VF
9
8
1
2
3
6 7
4
5
5
0
1
[RM] RM Multi-pin Connector (26 Pin)
Connect to Remote Control Unit RM-P210
by using the 26 pin camera cable.
In addition, power is supplied to the this
unit and the camera via this connector
from the remote control unit.
Connect to Remote Control Unit RM-P210
by using the 26 pin camera cable.
In addition, power is supplied to the this
unit and the camera via this connector
from the remote control unit.
2
[INTERCOM] Intercom Input Terminal
(XLR 5 Pin)
Input terminal for intercom headset. JVC
Headset KA-310U can be connected here.
(XLR 5 Pin)
Input terminal for intercom headset. JVC
Headset KA-310U can be connected here.
3
[INCOM LEVEL] Intercom Receiver
Volume
Use for adjusting the intercom headset re-
ceiver volume level.
Volume
Use for adjusting the intercom headset re-
ceiver volume level.
4
[INCOM MIC] Intercom Mic [ON/OFF]
Switch
[ON/OFF] switch for intercom headset
microphone. Set it to [ON] if the headset
microphone is to be used.
Switch
[ON/OFF] switch for intercom headset
microphone. Set it to [ON] if the headset
microphone is to be used.
Note
Besides Composite video signal, other
types of camera video signals which
could be output from the output terminal
of RM-P210 include RGB component,
Y/Cb/Cr component and YC separate
signal. The output signal could be se-
lected using the “OUTPUT” item under
the “SYSTEM” menu screen on the KY-
F560. (
types of camera video signals which
could be output from the output terminal
of RM-P210 include RGB component,
Y/Cb/Cr component and YC separate
signal. The output signal could be se-
lected using the “OUTPUT” item under
the “SYSTEM” menu screen on the KY-
F560. (
☞
page 21)
!
#
@