JR Direct The Ultimate Radio Control System XP8103 ユーザーズマニュアル
XP8103 Manual Addendum
Please refer to the info below for clarification before using these functions.
This information is applicable in all model types (Airplane, Helicopter, Glider).
The XP8103 offers two separate types of timer functions —
countdown and stopwatch. In the countdown mode, the trans-
mitter will beep at 30 seconds. At zero, the time will begin
counting up with a + indication. Up count will count up to
59:59 (59 minutes 59 seconds).
countdown and stopwatch. In the countdown mode, the trans-
mitter will beep at 30 seconds. At zero, the time will begin
counting up with a + indication. Up count will count up to
59:59 (59 minutes 59 seconds).
Count start and stop operations are activated by the snap
roll/trainer switch. But when using it as the trainer’s master
roll/trainer switch. But when using it as the trainer’s master
transmitter, start/stop by this switch is inhibited.
Accumulated Time (Integrated)
Accumulated time is for each model and returns to zero at 100
hours. You can use them as individual model’s maintenance
hours.
hours. You can use them as individual model’s maintenance
hours.
Timer (Function Mode)
Accumulated time
minutes
hours
minutes
hours
Countdown timer setting
time (0.00 to 59.50)
time (0.00 to 59.50)
Inhibit
Countdown Timer
Stopwatch
Timer setting time
NORMAL DISPLAY w/countdown timer function selected
Press to transfer the correct timer
data for the current model selected,
or to reset timer to zero
data for the current model selected,
or to reset timer to zero
DN
SELECT
CH
CH
CLEAR
UP
Press either key
to start/stop timer
to start/stop timer
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
simultaneously to enter/exit
the Function Mode
Press the DN and Select keys simul-
taneously to access the Function
Mode List Display
taneously to access the Function
Mode List Display
Press to select
Timer Setting:
Timer Setting:
↓
INH
↓
Countdown Timer
↓
Stopwatch
DN
SELECT
CH
CH
CLEAR
UP
To Servo Output
Indicator
Indicator
To Trainer
function
function
Press either key
to move arrow
to move arrow
Press to inhibit
Timer function or
to set Integ-T
value to 0
Timer function or
to set Integ-T
value to 0
or to increase or decrease
countdown timer settings
countdown timer settings
Press to move
cursor from timer
to Integ-T
cursor from timer
to Integ-T
When using the model select function (System Mode) to
change from models 1-10, it is necessary to push the clear
key once after the system has been returned to the normal
display to also transfer the timer data. If the clear key is not
pressed, the time set for the current model will change to
that of the time set for the
change from models 1-10, it is necessary to push the clear
key once after the system has been returned to the normal
display to also transfer the timer data. If the clear key is not
pressed, the time set for the current model will change to
that of the time set for the
previously used model.
Important Note:
Airplane 54
Helicopter 95
Glider 131
Manual Page