John Deere OMGX10742 J9 ユーザーズマニュアル
Service - 24
SERVICE
Lubricate Auger
Lubricate auger bearings (A), auger tubes (B), and
discharge fan (C) with General Purpose Grease.
discharge fan (C) with General Purpose Grease.
Lubricate Discharge Chute
Lubricate discharge chute (A) with WD-40 or equivalent.
Adjusting Discharge Chute Drive Tube
If discharge chute will not hold its position and tends to
rotate, adjust lock nut on end of discharge chute tube eye
rotate, adjust lock nut on end of discharge chute tube eye
bolt (A).
•
Tighten lock nut (B) 1/8 turn and check rotation of
discharge chute drive tube by turning chute control rod.
•
A small amount of resistance should be encountered.
DO NOT overtighten. Tighten until discharge chute holds
its position.
its position.
Chute Control Cable Hook-Up
Chute control cable is wound around discharge chute drive
tube 2 1/2 turns each way; both ends of equal length. This
will allow equal angle of discharge chute in both directions.
tube 2 1/2 turns each way; both ends of equal length. This
will allow equal angle of discharge chute in both directions.
Replacing Upper V-Belt
1. Remove the snowblower from the tractor, if necessary.
2. Remove damaged V-belt.
3. Install new V-belt on upper idlers as shown.
c
CAUTION: Avoid injury! Rotating auger is
dangerous.
• Park the machine safely and lock the park
brake before getting off the seat.
brake before getting off the seat.
• Turn the snowblower off.
• Stop the engine.
• Wait for all moving parts to stop.
• Disconnect spark plug wire(s) to prevent
engine from starting accidently.
engine from starting accidently.
C
B
B
A
A
M95959
B
A