Jeep 50-0283x-019 SERIES ユーザーズマニュアル
4
5. Locate the O.E.M. storage pocket mounted to
the rear passenger side of vehicle. Remove and
discard pocket by moving it upward and
outward. See figure 4.
discard pocket by moving it upward and
outward. See figure 4.
6. Using a pin router, razor knife, or suitable tool,
carefully trim plastic panel as shown to allow
clearance for VCP bracket. See Figure 5.
clearance for VCP bracket. See Figure 5.
Caution: Before cutting panel, check for
wiring or other componentry behind panel.
Cut only where indicated.
Cut only where indicated.
7. Install (2) two housing mounting brackets (item 8 pg 2)
as shown and secure using (3) three # 8 X 9/16"
screws (item 6 pg 2) on each side. See Figure 6.
screws (item 6 pg 2) on each side. See Figure 6.
FIGURE 4
FIGURE
5
FIGURE
6