Jensen VM9022 ユーザーズマニュアル

6

VM9022

5.

Complete wiring as illustrated in the wiring diagram on 
page 3. Once the wiring is complete, reconnect the 
battery negative terminal. If there is no ACC available, 
connect the ACC lead to the power supply with a switch.

After completing the wiring connections, turn the unit on to 
confirm operation (ignition switch must be on). If unit does not 
operate, recheck all wiring until problem is corrected. Once 
proper operation is achieved, turn off the ignition switch and 
proceed with final mounting of the chassis.

1.

Connect wiring adapter to existing wiring harness.

2.

Connect antenna lead.

3.

Carefully slide the radio into the half-sleeve, making 
sure it is right-side-up, until it is fully seated and the 
spring clips lock it into place.

Two cosmetic trim rings are packaged with the VM9022 for 
installation flexibility. The VM9022 will fit into most import 
dashes with little or no modification to the dash board/cavity. 
Some US domestic vehicle dashes will accept a Double-DIN 
chassis, but there is usually a small gap between the radio 
and dash piece after installation is complete. In this case, use 
the appropriate trim ring to conceal any gaps that may be 
present. 

The 4 tabs on the trim ring will snap into four holes on top and 
bottom of the mounting sleeve. 

The MediaLink allows you to connect a variety of external 
devices, including a VCR, DVD player, portable MP3 player, 
etc., to your VM9022 without removing the radio.

To install the MediaLink, connect it to the AUX-IN cables on 
the back of the VM9022 (see the Wiring Diagram on page 3), 
and then install the MediaLink in a location convenient for 
plugging in auxiliary devices.

When replacing the fuse, use a new 20A replacement fuse. 
Using a fuse with an improper rating could damage the unit 
and cause a fire.