Jasco 24702 ユーザーズマニュアル
3
Antenna placement with mounting base:
§
Before the following step, please make sure that you have enough protection when you try to drill on
wall to install the antenna.
wall to install the antenna.
§
Please check the signal reception and make sure you can get a good signal at the location where
you are going to install the antenna.
you are going to install the antenna.
1. Indoor wooden wall mounting installation:
Step 1: Mark the fixing position with a pencil or
pen (Please use the mounting base to
mark the position).
mark the position).
Step 2: Take out the attached screws, using
screw driver to fix these screws
through the mounting base and fix it
on the wall.
through the mounting base and fix it
on the wall.
Step 3: Attach the antenna to the mount base,
and check the signal reception.
2. Indoor concrete or RC wall mounting
installation:
Please note, when you use the electric drill, you should wear the eyes protection goggles,
and the drill bit must be fixed, to avoid any injury.
Step 1: Take a electric drill, use a drill bit
Please note, when you use the electric drill, you should wear the eyes protection goggles,
and the drill bit must be fixed, to avoid any injury.
Step 1: Take a electric drill, use a drill bit
to drill a 35mm deep hole. Then
clean the hole.
clean the hole.
Step 2: Take out the plastic pole, using
hammer to ham it into the hole
that made at step1.
that made at step1.
Step 3: Take out the screws, use screw
driver, screw them through the
mounting base onto the plastic
pole.
mounting base onto the plastic
pole.
Step 4: Attach the antenna to the mount
base, and check the signal
reception.
reception.
3. Indoor wall mounting installation with the Velcro:
Please note, clean the surface before stick the Velcro.
Step 1: Use the Velcro inside the box, and stick to the mounting base.
Step 2: Make sure the antenna can get a good signal reception at the location and position you are
Step 1: Use the Velcro inside the box, and stick to the mounting base.
Step 2: Make sure the antenna can get a good signal reception at the location and position you are
going to attach.
Step 3: Stick the mounting base with the Velcro, and make the mounting base is secure.
Step 4: Attach the antenna to the
Step 4: Attach the antenna to the
mount base, and check
the signal reception.
the signal reception.