Multiquip Speaker STX55Y6 ユーザーズマニュアル

1

3

4

5

2

F

L

Failure to understand the operation of the STX-SERIES Ride-
On Power Trowel could result in severe damage to the trowel
or personal injury.

The following sections are
intended to assist the operator with
pre-inspection and the initial start-
up of the STX-SERIES Ride-On
Power Trowel. It is extremely
important that these sections are
read carefully before attempting to

use the trowel in the field.  DO NOT use your Ride-On Power
Trowel until these sections are thoroughly understood.

Determine if the hydraulic oil is low by observing the level of oil
in the hydraulic Oil Sight Glass (Figure 7).  The hydraulic tank
has an elevated overflow bottle.  DO NOT remove the fill cap
when the oil is hot or spillage will occur.

See Figures 2 and 3 (Pages 20 and 21) for the location of controls
and indicators referenced in this manual.

1.

When checking or adding oil, place the machine so the
engine is level.

2.

Pull the engine oil dipstick from its holder (item 1 Fig 6).

3.

Determine if engine oil is low (item 4). Oil should be
between the upper limit and lower limit (add oil) lines.

4.

If oil is below the "Add Engine Oil" line add oil up to upper
limit on the dipstick.  Allow enough time for any added oil to
make its way to the oil pan before rechecking.

1.

2.

3.

4.

5.

DO NOT overfill the oil pan with engine oil.  Always keep the
engine oil level between the upper and lower limit lines on
the dipstick.

3

2

1

1.

2.

3.

 NOTE