Multiquip Boat MT-86D2 ユーザーズマニュアル
MT-86D2 TAMPING RAMMER— OPERATION AND PARTS MANUAL — REV. #3 (06/18/07) — PAGE 9
■ ALWAYS stop the engine before servicing, adding fuel and
oil.
■ NEVER run engine without air filter. Severe engine may
occur.
■ ALWAYS service air cleaner frequently to prevent carburetor
malfunction.
■ ALWAYS check the machine for loosened threads or bolts
before starting.
■ ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using rammer.
■ ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of
the reach of children.
the reach of children.
■ DO NOT operate this equipment unless all guards and
safety devices are attached and in place.
■ CAUTION must be exercised while servicing this equipment.
Rotating and moving parts can cause injury if contacted.
■ Keep all inexperienced and unauthorized people away
from the equipment at all times.
■ Unauthorized equipment modifications will void all
warranties.
■ NEVER pour or spray water over the engine.
■ Test the engine ON/OFF switch before operating. The
■ Test the engine ON/OFF switch before operating. The
purpose of this switch is to shut down the engine of the
rammer.
rammer.
■ Refer to the Yanmar Engine Owner's Manual for engine
technical questions or information recommended by
Multiquip for this equipment.
Multiquip for this equipment.
TRANSPORTING
■ ALWAYS shutdown engine before transporting.
■ Tighten fuel tank cap securely and close fuel cock to
■ ALWAYS shutdown engine before transporting.
■ Tighten fuel tank cap securely and close fuel cock to
prevent fuel from spilling.
■ Drain fuel when transporting rammer over long distances
or bad roads.
■ When placing the rammer inside a truck-bed for transport,
always tie-down the rammer
MAINTENANCE
■ NEVER lubricate components or attempt service on a
■ NEVER lubricate components or attempt service on a
running rammer.
■ ALWAYS allow the rammer a proper amount of time to
cool before servicing.
■ Keep the rammer in proper running condition.
■ Fix damage to the rammer immediately and always
■ Fix damage to the rammer immediately and always
replace broken parts.
■ Dispose of hazardous waste properly. Examples of
potentially hazardous waste are used motor oil, fuel
and fuel filters.
and fuel filters.
■ DO NOT use food or plastic containers to dispose of
hazardous waste.
MT-86D2 TAMPING RAMMER — RULES FOR SAFE OPERATION
■ In emergencies always know the location of
the nearest phone or
keep a phone on the job
site. Also know the phone numbers of the
nearest
nearest
ambulance, doctor and fire
department. This information will be invaluable
in the case of an emergency.
in the case of an emergency.
EMERGENCIES
■ ALWAYS know the location of the nearest fire
■ ALWAYS know the location of the nearest fire
extinguisher and first aid kit.