MTD Series 020 ユーザーズマニュアル

Figure 3-2

Figure 3-3

Figure 3-4

Remove the hairpin clips from the handle brackets 
and remove the carriage screws and wing nuts from 
the lower handle.

Place the bottom holes in lower handle (notch 
pointing down) over the pins on the handle 
brackets and secure with hairpin clips. See 
Figure 3-2.
Insert carriage screws through upper hole in 
lower handle from the inside and secure with 
wing nuts. See Figure 3-2.

2.     a.  Unfold the upper handle until it aligns with lower  
 

handle. Make sure the rope guide is on the right  

 

side of upper handle. See Figure 3-3.

IMPORTANT: Make sure the cables are routed outside 
the lower handle. Also, do not crimp the cables while 
lifting up the handles.

         b.  Secure the two handles by tightening the star  
 

knobs (carriage bolts must be seated properly  

 

into the handle). See Figure 3-3.

3.      Loosen the wing nut that secures the rope guide to  
         the right side of upper handle.
         a.  Pull the starter rope out of the engine slowly.  
 

See Figure 3-4.

         b.  Slip the starter rope into the rope guide.
         c.  Tighten the wing nut. See Figure 3-4.

1.

a.

b.

Make sure the cables 

are routed outside the 

lower handle. Also, do 

not crimp the cables 

while lifting up the 

handles.