Multi-Tech Systems MultiVOIP GSM SIP-to-Cellular Gateways MVPGSM-2 ユーザーズマニュアル
Chapter 4: Configuring your MVPGSM
Multi-Tech Systems, Inc.
MVPGSM
34
Wireless Interface parameter definitions
Field Name
Values
Description
Select Channel
1 – 2
Select which channel you want to set parameters for.
Disable Interface
Check box
Enable or Disable the interface.
Use Module for
DTMF Generation
DTMF Generation
Check box
Enable or Disable DTMF generation. When checked, the wireless module will
generate DTMF tones to the cell network. If this is enabled, out of band DTMF
must be set in Voice/Fax and out of band DTMF must be set to the remote SIP
end point.
generate DTMF tones to the cell network. If this is enabled, out of band DTMF
must be set in Voice/Fax and out of band DTMF must be set to the remote SIP
end point.
Enable Caller ID
Check box
Enable or Disable Caller ID reporting. This allows Caller ID from the cell network
to be passed over IP.
to be passed over IP.
No Response Timer Range 5 - 20 Set the timeout in seconds, for the wireless module to wait for a valid response
from AT commands.
Minimum Signal
Quality Required
Quality Required
Range 0 - 31 Set the lowest allowed signal quality for the wireless channel to initiate a call.
SIM Pincode
-
SIM PIN Numeric
Should your SIM card get locked out, your provider can give you the PIN code
for the SIM on this channel.
for the SIM on this channel.
SIM PUK Numeric
Should your SIM card get locked out, your provider can give you the PUK code
for the SIM on this channel.
for the SIM on this channel.
Modem Setup
-
Five areas are available for initialization strings to be sent to the internal
wireless modules.
wireless modules.
Copy Channel
(button)
(button)
-
Will copy all settings from the current channel to the other available channels.
Default (button)
-
Resets parameters back to their factory default settings.