Jacuzzi GQ99000 ユーザーズマニュアル

3-Prong power cable

No. 20, 1/4” 

Screw hole  

(2 both sides)

No. 10 Screw hole 

(2 both sides)

Modular plug

for control panel

Modular plugs

for lamps (1 to 4)

Mount the control box to a stud beam or secure wall using four 

No. 10 screws, or four No. 20, 1/4 inch screws. The mounting 

holes for the screws are shown in Figure 5. 
note: The modular plugs are also shown in the figure. Position 

the control box in the most advantageous way, considering the 

length and direction of the modular cables. 

Caution: The power cable must be connected to a dedicated 

ground fault circuit interruptor (GFCI). No other outlet is 

acceptable to this equipment. 
Attach the control box securely to the mounting location. 

After preparation of the bath shell for drilling the hole for the 

control panel and each Chromatherapy lamp, proceed with drilling 

the holes. This should be completed by a technican experienced 

in drilling through a fine acrylic material. 
The areas of the holes have been covered with masking tape and 

carefully outlined to indicate the location and size of the holes. 

The tape will help prevent chipping of the acrylic. 

The control panel has been located a minimum of one inch 

above the level of the overflow drain. It has been marked for a 

1-1/16 inch diameter with a 5/32 inch notch at the right center, see 

Figure 3. 
Caution: Drill the holes from the inside of the unit carefully 

to prevent chipping or cracking of the acrylic shell. Use a drill 

guide for best results and begin drilling at low speed until the 

drill penetrates the acrylic layer, then use a high speed for the 

remaining material.
1. 

First use a 5/32 inch drill bit to carefully drill the notch. 

2. 

Use the 5/32 inch drill bit to drill a pilot hole for the 

1-5/8 inch hole. 

3. 

Use a 1-1/16  inch drill bit to complete the hole for the lamp. 

4. 

Remove any and all burrs or roughness from the inside of 

the hole.

The lamp(s) has been located a minimum of 4 inches below the 

normal water level. It has been marked for a 1-5/8 inch diameter, 

see Figure 4.
Caution: Drill the holes from the inside of the unit carefully 

to prevent chipping or cracking of the acrylic shell. Use a drill 

guide for best results and begin drilling at low speed until the 

drill penetrates the acrylic layer, then use a high speed for the 

remaining material.
1. 

Use the 5/32 inch drill bit to drill a pilot hole for the 1-1/16 

inch hole. 

2. 

Use a 1-5/8  inch drill bit to complete the hole for the control 

panel.