Micron Technology MERIDIAN 850 ユーザーズマニュアル
57
Password
Creates passwords at bootup for accessing SETUP values or disabling
current passwords. There are two kinds of password, the bootup password
and SCU (SETUP) password. To create or change these passwords, run
SETUP and select Password under the Startup menu. The following dialog
box appears:
current passwords. There are two kinds of password, the bootup password
and SCU (SETUP) password. To create or change these passwords, run
SETUP and select Password under the Startup menu. The following dialog
box appears:
Boot Password
Creates a password to access to the system at bootup, or disables the
current password.
To create or change a password, enter 4 to 8 characters in the text box.
Each character is displayed by an asterisk ( * ). Using the <Tab> key,
highlight Enable password for Boot-up. When you press the <Spacebar>,
an [X] appears. Press <Enter>. Next, reenter the password to verify it,
then, press <Enter>. A message appears stating that the password has been
verified, then tells you to press any key to continue. After the password
dialog box closes, an [X] appears next to the Boot Password menu item.
current password.
To create or change a password, enter 4 to 8 characters in the text box.
Each character is displayed by an asterisk ( * ). Using the <Tab> key,
highlight Enable password for Boot-up. When you press the <Spacebar>,
an [X] appears. Press <Enter>. Next, reenter the password to verify it,
then, press <Enter>. A message appears stating that the password has been
verified, then tells you to press any key to continue. After the password
dialog box closes, an [X] appears next to the Boot Password menu item.
Note: If you enter the wrong verification password, you’ll have to start again.
Removing the boot-up password
Highlight Enable password for Bootup and press <Spacebar>. The [X]
mark goes away.
mark goes away.
Chapter 5 - Using SETUP
MERID850.PM5
7/17/95, 9:13 AM
57