Metra Electronics 99-3009 ユーザーズマニュアル

ページ / 4
3
4
Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Using a 
small set of pliers, grasp the retaining clip on 
the back of the gear shifter handle and 
remove the clip.  Remove the gear shifter 
handle.  Unclip the center console and 
remove.  Remove (2) 7mm hex-head 
screws exposed under the climate controls.  
Unclip the radio trim bezel and remove.  
Remove (2) 7mm hex-head screws securing 
the factory head unit and disconnect the 
wiring.
Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Unclip 
the entire dash trim bezel.  Remove the 
screws securing the factory head unit and 
disconnect the wiring.
1
1
PONTIAC Grand Prix  1994-02
PONTIAC Grand Prix  1997-99
2
2
Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Open 
the glove box and remove (2) Phillips screws 
exposed on the right edge of the radio trim 
bezel.  Unclip the bezel and remove.   
Remove (2) 7mm hex-head screws securing 
the factory head unit and disconnect the 
wiring.
1
PONTIAC Sunfire  1995-99
Cut and remove all mounting tabs on the 
Radio Housing EXCEPT tabs "C". (see 
Fig. A).  
 Using a dremel tool, cut and remove 
the shaded portions of the sub-dash plastic.  
This will provide the necessary depth for 
installation.  (see Fig. B).  Skip to the 
Installation Instructions for ALL VEHICLES 
on Page #5.  
 
2
Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Unclip 
the radio trim bezel.  Remove (4) 7mm hex-
head screws securing the factory head unit 
and disconnect the wiring.
1
PONTIAC Trans Am / Firebird  1993
2
"C"
"C"
"B"
"C"
Fig. A
Fig. B
Cut and remove all mounting tabs on the 
Radio Housing EXCEPT tabs "C".  The 
mounting tabs can be identified by the 
stamped letter on the back of each tab.  Skip 
to the Installation Instructions for ALL 
VEHICLES on Page #5. 
Cut and remove all mounting tabs on the 
Radio Housing EXCEPT tabs "B".  The 
mounting tabs can be identified by the 
stamped letter on the back of each tab.  Skip 
to the Installation Instructions for ALL 
VEHICLES on Page #5. 
Cut and remove all mounting tabs on the 
Radio Housing EXCEPT tabs "C".  The 
mounting tabs can be identified by the 
stamped letter on the back of each tab.  Skip 
to the Installation Instructions for ALL 
VEHICLES on Page #5.