Mercedes Benz Comand 6515 6786 13 ユーザーズマニュアル
152
Navigation
Route guidance
Muting current voice instructions
Press
J.
The current announcement is stopped.
You will hear the next navigation
announcement normally.
You will hear the next navigation
announcement normally.
Switching voice instructions On/Off
Switching off
During a navigation announcement
press
press
J for 2 seconds.
You will hear a confirmation beep if the
beep tones option was activated in the
system settings (
beep tones option was activated in the
system settings (
page 217).
The message
Voice Announcements
Muted
will appear briefly. Further route
guidance takes place using only the
symbols in the display. If a new route
guidance cycle is started, the
announcements are automatically
switched on again.
symbols in the display. If a new route
guidance cycle is started, the
announcements are automatically
switched on again.
Switching on again
Press
j.
The navigation displays are only visible
while route guidance is active.
while route guidance is active.
To switch to the navigation display from
another display, e.g. from CD operation:
another display, e.g. from CD operation:
Press
b or c.
Two examples are shown below:
Display example 1:
The road you are currently driving on is
shown on the status bar, in this case
shown on the status bar, in this case
I-90
.
The indication
120 mi
is the distance to
the next driving maneuver.
If the GPS position display (
page 170) is
active, the GPS data are shown instead of
the street name.
the street name.
Navigation displays
i
Using the multifunction steering wheel
buttons, the display unit can be
changed between km or miles (see
your vehicle’s Operator’s Manual).
buttons, the display unit can be
changed between km or miles (see
your vehicle’s Operator’s Manual).
When the display unit is set to
miles, the COMAND will indicate
distances in miles (mi) or feet (ft).
miles, the COMAND will indicate
distances in miles (mi) or feet (ft).
When the display unit is set to km,
the COMAND will indicate
distances in kilometers (km) or
meters (m).
the COMAND will indicate
distances in kilometers (km) or
meters (m).