Magma MDR 24/96 ユーザーズマニュアル

MDR 

24/

96

(3) DIO

•

8 or OPT

•

8 cards for MDR24/96

(3) DIO

•

8 or OPT

•

8 cards for D8B

(1) Clock I/O card for D8B
(6) ADAT Optical cables
(1) 75

Ω BNC word clock cable

1.  Connect three ADAT Optical cables from the MDR24/96 Optical Outputs to

the Optical Inputs on the corresponding D8B I/O cards.

2.  Connect three ADAT Optical cables from the MDR24/96 Optical Inputs to

the Optical Outputs on the corresponding D8B I/O cards.

3.  When ADAT Optical is used, the D8B must have a Clock I/O card

installed. To make the D8B the clock master, connect its Word Clock Out
to the MDR24/96 Word Clock In. To make the MDR24/96 the clock
master, connect its Word Clock Out to the D8B Word Clock In.

1.  If you have DIO•8 cards installed, set the Tape Input and Tape Output

format for each card to ADAT. OPT•8 cards need no configuration.

2.  If the MDR24/96 is the clock master, set the Sample Clock to Internal; If

the MDR24/96 is a clock slave, set the Sample Clock to Word Clock and
depress the 75

Ω termination button on the Sync card.

3.  Set the Sample Rate to  44.1 kHz or 48 kHz according to your preference.

1.  If you have DIO

•

8 cards installed, set the Tape Input and Tape Output

format for each card to ADAT. OPT

•

8 cards need no configuration.

2.  If the D8B is the clock master, set the Sample Clock to either 44.1 k

or 48 k Internal; if it is a clock slave, then set the Sample Clock

to either 44.1 kHz or 48 kHz. Set the Sample Rate to match the Sample
Rate

 selected on the MDR24/96.