LUCE PT-L6510E ユーザーズマニュアル

36

(e.g. Deleting the data of “USER1”)
1. Choose “USER MODE” on “OPTION2” and press

the “ENTER” button.

2. Choose “DELETE” using the 

 or 

 buttons.

3. Choose the address (USER1) you want to delete

data from using the 

 or 

 buttons and press the

“ENTER” button.

4. After recorgnizing the flashing of the address

display, press the “ENTER” button again to delete
the data of the address.

 Registering/Deleting/

(For RGB/YP

B

P

R

 signals only)

Once adjustment settings are registered with User
Mode, they are automatically loaded each time the
projector is powered up. It is not necessary to readjust
settings at every power on.

(e.g. Registering positioning data with “USER1”)

1. Apply an input signal you want to register, and

then adjust the picture position, size, and others.

2. Choose “USER MODE” on “OPTION2” and press

the “ENTER” button.

3. Choose “USER1” using the  

 or 

 buttons and

press the “ENTER” button.

4. After recognizing the flashing of the USER1

address display, press the “ENTER” button again.

5. The above adjusted settings has been registered

with “USER1”. Similarly you can also register
settings with “USER2” or “USER3”.

UNIT ID is used to set projector IDs when the user
wishes to control two or more projectors either
simultaneously or separately.

"ALL":  The projectors can be simultaneously

controlled from any remote control regardless
of their ID settings.

"1":  The projector can be controlled from the remote

control with its projector ID set to “1”.

"2":  The projector can be controlled from the remote

control with its projector ID set to “2”.

"3":  The projector can be controlled from the remote

control with its projector ID set to “3”.

• Unit ID is set to “ALL” by default.  Hence ID

number need not be set when only one

projector is used.

• If the projectors are given ID numbers, their

remote controls must be assigned the same

ID numbers, respectively.

• If the unit IDs of two or more projectors are

set to “ALL”, the user will not be able to

control them separately.

• The projector can be turned ON/OFF from

the remote control only if the projector ID is

set in the remote control. For the details of

projector ID setting, see page 15.

SET ID

ALL

1

2

3

USER MODE

ENTRY

USER1

SELECT

ADJ

ESC

USER MODE

ENTRY

USER1

DELETE

USER1

SELECT

ADJ

ESC

The User Mode can be displayed by following the
steps described in “SIGNAL MODE” on page 31.

• The user address has “USER1” to “USER3”.