LUCE PT-L6510E ユーザーズマニュアル

37

The projector is equipped with an RS-232C standard serial terminal at the rear. It is therefore possible to connect it

to a computer for control.

Transmission from the computer begins with STX, then the command, parameter and ETX are sent in this order.
Colon (:) is not required when transmitting the command which does not need a parameter.

Sync method

Baud rate

Parity

Character length

Stop bit

X parameter

S parameter

Start-stop transmission

9 600 bps

None

8 bit

1 bit

None

None

• On commencement of lamp lighting, commands cannot be sent or responses received for approximately 10

seconds. Be sure to send any commands and receive responses 10 seconds. (Applies to the PT-L6600E /

PT-L6600EL only)

• When transmitting several commands, wait for a response from the projector before sending the next command.

When sending commands without parameters, a colon is not necessary.

• When it is unnecessary to designate an ID code, send the format without the part to ID designate it.

• If a wrong command is received, the projector sends ER401 back to the computer.
• When using control from the remote terminal, commands cannot be received at the serial terminal.
• Projector ID supported on the RS-232C interface is 0 (ALL) to 99.
• The remote control ID is set from 0 to 3. If a command is sent with a projector ID specified, the projector will return

answer back only if the ID contained in the command matches the projector ID or the projector ID is set to ALL.

STX

C1

C2

C3

:

P1

P2

P3

P4

P5

ETX

AD

I 1

I 2

:

ID   characters

OUT

IN

OUT

IN

TXD

RXD

GND

CTS

RTS

NC

Send data 

Receive data

Connected internally

Ground

NC

Connected 

internally

NC

RXD

TXD

GND

RTS

CTS

NC

Receive data 

Send data

NC

Ground

NC

Connected 

internally

NC