Linksys EFG120 ユーザーズマニュアル
4
Chapter 2: Getting to Know the Network Attached Storage
The Back Panel
The Back Panel
EtherFast Network Attached Storage (120GB with PrintServer)
Chapter 2: Getting to Know the Network Attached Storage
The Back Panel
The Network Attached Storage’s ports and Reset button are located on the back panel.
LAN Port
This LAN (Local Area Network) port connects to an Ethernet network device, such
as a switch or router. (You can also connect the Network Attached Storage directly
to a computer.)
as a switch or router. (You can also connect the Network Attached Storage directly
to a computer.)
PRINTER Port
The PRINTER port connects to a printer using a parallel cable.
Reset Button
This button is used to reset the Network Attached Storage’s IP address and
password to their factory defaults.
password to their factory defaults.
Press and hold this button for three seconds. The IP address will be reset to the
default value of 192.168.1.77, with a subnet mask of 255.255.255.0, and the
password will be reset to its default, admin. After the reset has occurred, the
Network Attached Storage will beep once.
default value of 192.168.1.77, with a subnet mask of 255.255.255.0, and the
password will be reset to its default, admin. After the reset has occurred, the
Network Attached Storage will beep once.
POWER Port
Connect the power adapter here.
Figure 2-1: Back Panel
IMPORTANT: Never remove the power adapter while the Network
Attached Storage is powered on. Make sure you press the power
button on the front panel to power off the Network Attached Storage
before removing the power adapter.
Attached Storage is powered on. Make sure you press the power
button on the front panel to power off the Network Attached Storage
before removing the power adapter.