Interlink electronic X70/X80 ユーザーズマニュアル

Multifunctional Settings (continued)

OPTION Menu

With the OPTION menu, the items shown in the table below can be
performed. Perform each operation in accordance with the
instructions in the table below.

: SELECT

MAIN
PICTURE-1
PICTURE-2
INPUT
AUTO
SCREEN
OPTION
NETWORK

VOLUME
SPEAKER
IR REMOTE
IR REMOTE ID
LAMP TIME
FILTER TIME
SERVICE
PIN LOCK

16
TURN ON

ALL
1234 h
4321 h

TURN ON

Item

Description

VOLUME

Adjust the volume using the

buttons. :

High

Low

SPEAKER

Select the TURN ON or the TURN OFF using the

buttons. :

TURN ON

TURN OFF

When the TURN ON is selected, the built-in speaker works.

IR REMOTE

Select a remote sensor using the

button (1), then switch it

using the ENTER button (2). :

(1) 1:FRONT

2:TOP 3:REAR (2) (Off) (On)

memo

A sensor cannot be turned off when the other two are off.

Always at least one sensor is on.

IR REMOTE ID

Select a number as an ID number for remote control using the

buttons. :

ALL

1 2 3

The projector is controlled by the remote control whose ID CHANGE switch is
set into the position of the same number as this number. When the ALL is
selected, the projector is controlled by a remote control irrespective of the
position of the ID CHANGE switch.

memo

Please refer to the section “Using The Remote ID Feature”.

LAMP TIME

Pressing the RESET button for about 3 seconds displays the LAMP TIME menu.
Select the RESET using

button to reset the timer. :

RESET

CANCEL

Selecting the RESET resets the count of the lamp timer to 0.

memo

Perform this function only when you have replaced the lamp. The lamp

timer counts the used time of the current lamp, to display the messages about
the lamp. Incorrect performing causes incorrect operation of the messages.

memo

About replacing the lamp, please refer to the section” Lamp”.

FILTER TIME

Pressing the RESET button for about 3 seconds displays the FILTER TIME
menu.
Select the RESET using

button to reset the timer. :

RESET

CANCEL

Selecting the RESET resets the count of the lamp timer to 0.

memo

Perform this function only when you have cleaned or replaced the air

filter. The filter timer counts the used time of the air filter after cleaning or
replacement, to display the messages about the air filter. Incorrect performing
causes incorrect operation of the messages.

memo

About caring for the air filter, please refer to the section “Air Filter”.

OPTION
IR REMOTE
1:FRONT
2:TOP
3:REAR
ENT

(This table is continued to the following page.)