Intel SR1500AL ユーザーズマニュアル

ページ / 180
Intel
®
 Server System SR1500AL User’s Guide
53
10. Install the PCI riser assembly into the server system. For instructions, see 
“Installing the PCI Riser Assembly”
.
11. Install the processor air duct. For instructions, see 
“Installing the Processor Air 
Duct”
.
12. Install the server system cover. For instructions, see 
“Installing the System Cover”
13. Plug all peripheral devices and the AC power cable(s) into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See 
“Safety 
Information”
2. Power down the server and unplug all peripheral devices and the AC power 
cable(s). 
3. Remove the server system cover. For instructions, see 
“Removing the System 
Cover”
4. Remove the processor air duct. For instructions, see 
“Removing the Processor Air 
Duct”
.
5. Remove the PCI riser assembly. For instructions, see 
“Removing the PCI Riser 
Assembly”
.
6. Open the rear retention clip by pushing the blue slide upward and rotating clip to 
the fully open position (see letter “A”).
7. Remove the PCI add-in card from the riser card connector (see letter “B”).
Figure 43. Removing a Full Height Add-In Card
8. Close both retention clips. 
Note: Make sure that all empty add-in card slots have filler panels installed.
9. Install the PCI riser assembly into the server system. For instructions, see 
“Installing the PCI Riser Assembly”
.
AF000362
A
B