Intel NetStructure 05-2450-001 ユーザーズマニュアル

16

CHEETAHSTART: Building shared memory.
CHEETAHSTART: Done.
Starting ssp_x86Linux_boot:                  [ OK ]
Starting Intel(R) NetStructure(TM) DM-family board(s) download phase.
Configuring and downloading board succeeded boardNumber=1
TBASSIGN: Board: 1 TDM Bus type and speed configured
REGVOX: Adding DM3 Devices ...
REGVOX: Adding DM3 Devices Done
Starting Telephony System Monitor :          [ OK ]
Starting Clocking Server :                   [ OK ]
Starting Clocking Daemon :                   [ OK ]
Starting fault detection on all boards.
Successfully started fault detection on all boards.
Starting Board Watch :                       [ OK ] 

STARTING INTEL DIALOGIC SERVICES COMPLETE.

Before you use the HMP Software you must obtain and activate a license. Refer to the Intel 
NetStructure Host Media Processing Release 1.5 for Linux License Manager Administration 
Guide.

Silent installation allows you to predefine the answers that you would normally supply to the setup 
program interactively. A silent install is recommended when no user interaction is intended. 

Before you begin a silent install, you must meet the prerequisites given in 

, on page 9. Then, follow steps 1 through 3 in 

, on page 10. After you complete step 3, continue with the following 

steps:

1. To display a list of the package names that can be silently installed, enter the following 

command:

./install.sh --silent

The following messages are displayed:

Usage: ./install.sh --silent <PKG1> <PKG2> ... <PKGn>

Valid package selections are:

-------------------------------

DLGChmp        Intel(R) NetStructure(TM) Host Media Processing Software

DLGCsnmp       SNMP Agent Software

DLGCdocs       Documentation

ALL            All available packages

2. Enter the silent install command with the packages you want to install. For example, if you 

want to install HMP software and the associated documentation, use the following command:

./install.sh --silent lsb-intel-hmp-hmp lsb-intel-hmp-docs

See Table 3 for a list of all the packages.

3. Run 

config.sh

 at least once after installing the software. 

4. Activate an HMP Software license file as described in Chapter 3, “Activating a License” of the