Infortrend EONSTOR A16E-G2130-4 ユーザーズマニュアル

EonStor A16E-G2130-4 Installation and Hardware Reference Manual  

BEFORE powering on the EonStor subsystem, please check the following: 

 

Memory Modules – Memory modules have been correctly installed on the 

controller boards. You may skip this if you have not changed the pre-installed 

module.    

 

BBU Modules – If used, that the BBU module has been installed correctly. 

 

Hard Drives – Hard drives have been correctly installed on the drive trays. 

 

Drive Trays – ALL the drive trays, whether or not they have a hard drive, have 

been installed into the subsystem. 

 

Cable Connections – The iSCSI ports on the subsystem have been correctly 

connected to the initiators or the Ethernet network. 

 

Power Cords – The power cords have been connected to the PSU modules on the 

subsystem and plugged into main power. 

 

Ambient Temperature – All the subsystem components have been acclimated to 

the surrounding temperature. 

 

When powering on the EonStor subsystem, please follow these steps. 

 

 Step 1. 

Power on the network connection devices. 

These devices include the Ethernet switches, iSCSI HBAs, and any 

other such devices that have been connected to the EonStor A16E 

subsystem. Please refer to the documentation that came with your 

network device to see the power on procedure. 

 Step 2. 

Power on the EonStor subsystem. 

The EonStor subsystem should only be powered on after all the network 

connection devices have been powered on. Consult your network 

administrators for proper network configurations. The power on 

procedure for the EonStor subsystem is described below. 

 Step 3. 

Power on the initiators. 

4-6 

Power On