Ingenico 6500 ユーザーズマニュアル

 

 

Ingenico 6500 User’s Guide 

117 

 

 

This section describes how to resolve error messages that may appear on your Ingenico 
6500 device display if using IBMEFTDL. 

13.1 

If the Card Read Error message displays on the device after swiping a card through the 
MSR: 

 

Try swiping the card a few more times, varying the speed at which the card is 
physically drawn through the reader. 

 

Try swiping the card in the reverse direction (i.e., if swiping the card from top to 
bottom, try swiping the card from bottom to top, front to back: back to front). 

 

Make sure that you are swiping the card in a straight line (i.e., make sure the MSR 
card is always touching the bottom of the MSR track). 

 

If none of these actions work, then the MSR card is worn and cannot be read 
electronically. Enter the card number manually. 

 

If the register is reloaded immediately after powering up, the Ingenico 6500 may 
not come up in the correct state. Signing in at the register and seeing if the 
Ingenico 6500 display reads “Please Slide Card” can determine this. If it does not 
(i.e., display continues to read, “Closed”), then perform the same steps as for the 
next error message, 

13.2 

If the EFT Device Not Available message displays on the register, perform the following 
steps: 

1.  Check to make sure the Ingenico 6500 is on and is displaying the first prompt screen of 

your application software. 

2.  On the register, press the Clear key and select the transaction type again. If the 

problem persists, continue to step 3. 

3.  To restart the Ingenico 6500 device, press Cancel + 0 + Enter simultaneously. 

The Ingenico 6500 restarts and the first prompt screen of the application software 
displays. 

4.  On the register, press the Clear key and select either the CREDIT or DEBIT 

transaction type again.