IBM CISCO R2E2 ユーザーズマニュアル

Appendix B:  Template file (Tivoli Netcool/Proviso pre-v4.4.3 only)

90 

IBM Tivoli Netcool/Proviso Cisco IP Telephony 2.4.0.0 Technology Pack

The following table describes the values that you must provide for these UBA parameters. 

Additional information about UBA parameters 

This section provides more information about the INSTANCES, URI, and DB_USERNAME parameters.

INSTANCES 

The DataChannel UBA application supports multiple instances of technology packs running in a single channel 
component. Therefore, there must be a way to guarantee that the UBA parses the correct design file and reads 
the appropriate bulk input files. The 

INSTANCES

 parameter helps ensure that the DataChannel UBA application 

performs the correct operation for a specific technology pack. 

The Cisco IP Telephony Technology Pack provides an 

INSTANCES

 parameter in its 

voip_cisco_ipt_sample_dc.cfg

 template file. You supply an arbitrary string — referred to as a group alias 

— to the 

INSTANCES

 parameter. After you define the 

INSTANCES

 parameter with a specific string, make sure 

you specify this string wherever <instance> appears in the template file. 

You can associate this group alias with any arbitrary string. For example, you might associate this group alias with 
the location (for example, 

BOSTON

, 

LOWELL

, 

BERLIN

, 

PARIS

, and so forth) of the data source. 

 

Replace with the channel number that was configured for this technology pack. This 
channel number appears in the dc.cfg file. 

Replace with the UBA Bulk Collector number that was configured for this technology 
pack. This collector number appears in the dc.cfg file. 

<instance> 

Replace with an arbitrary string that identifies a group alias to be associated with 
subsequent lines in this section of the dc.cfg file. See Additional information about 
UBA parameters on page 90 for more information on this UBA parameter value. 

The template file specifies VOIP_CISCO_IPT as an example. If you replace this 
string with one of your own, make sure that you replace it in the other parameters 
where it is specified. 

Replace with the correct time zone, as specified in the /etc/default/init file 
on the source host.

For example: 

UBA.1.1.VOIP_CISCO_IPT.TIMEZONE=GMT

The time zone must be set correctly. Otherwise, the pack will not deploy. 

<input_files_location> 

Specify 

the location of the bulk input files that the device generates, and 

the URIs of 

each 

CCM

 Publisher data source defined in the 

odbc.ini

 file.

See Additional information about UBA parameters on page 90 for more information about 
this UBA parameter value.