HP XC System Software 3.2.1 ユーザーズマニュアル
e.
Press the Enter key for no boot options.
f.
When prompted, save the entry to NVRAM.
For more information about how to work with these menus, see the documentation that
came with the HP Integrity server.
came with the HP Integrity server.
13. Perform this step on all nodes except the head node. From the Boot Configuration menu,
select the Edit OS Boot Order option.
Do the following:
a.
Use the navigation instructions on the screen to move the Netboot entry you just
defined to the top of the boot order.
defined to the top of the boot order.
b.
If prompted, press the Enter key to select the position.
c.
Enter x to return to the Boot Configuration menu.
14. Perform this step on all nodes, including the head node. Select the Console Configuration
option, and do the following:
a.
a.
Enable the P Serial Acpi(HWP0002,PNP 0A03,0)/Pci(1|1) Vt100+ 9600 option on HP
Integrity rx4640 servers.
Integrity rx4640 servers.
b.
When prompted, save the entry to NVRAM.
c.
Enter x to return to the previous menu.
15. Turn off power to the node:
a.
Press Ctrl-B to exit the console mode.
b.
Enter CM to display the Command Menu.
c.
Enter PC and enter off to turn off power to the node.
4.9.6 Preparing HP Integrity rx8620 Nodes
Follow this procedure to prepare each HP Integrity rx8620 node.
IMPORTANT:
Integrity rx8620 Nodes are configured with static addresses, not DHCP. On an
HP XC system with one or more Integrity rx8620 nodes, you must configure the Management
Processor (MP) on all nodes for static IP addresses rather than DHCP.
Processor (MP) on all nodes for static IP addresses rather than DHCP.
General Hardware Preparation
The connection of nodes to ProCurve switch ports is important for the automatic discovery
process.
process.
1.
Connect the Gigabit Ethernet ports on the HP Integrity rx8620 Core IO boards into the
ProCurve 28xx switch at the next available ports. Use one Gigabit Ethernet port for each
partition, for a total of two ports for one HP Integrity rx8620 node.
ProCurve 28xx switch at the next available ports. Use one Gigabit Ethernet port for each
partition, for a total of two ports for one HP Integrity rx8620 node.
On each HP Integrity rx8620 node, connect partition 0 to the highest-numbered available
open port, and connect partition 1 to the next lower-numbered port. Repeat this step for the
next HP Integrity rx8620, and so on.
open port, and connect partition 1 to the next lower-numbered port. Repeat this step for the
next HP Integrity rx8620, and so on.
See
for more information.
2.
Connect the Quadrics boards in the HP Integrity rx8620 partitions to the Quadrics switch
using the same pattern as the Gigabit Ethernet connections to the ProCurve 28xx switches.
using the same pattern as the Gigabit Ethernet connections to the ProCurve 28xx switches.
Connect partition 0 of the first HP Integrity rx8620 server to the highest available Quadrics
switch port, which is followed by partition 1 to the next highest available switch port, which
is followed by partition 0 of the second HP Integrity rx8620 server, and so on.
switch port, which is followed by partition 1 to the next highest available switch port, which
is followed by partition 0 of the second HP Integrity rx8620 server, and so on.
shows the HP Integrity rx8620 Core IO board and the appropriate connections to the
administration network and console network.
4.9 Preparing the Hardware for CP6000 (Intel Itanium) Systems
131